C-Max Owners Club banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
  • Service engine light on
  • Service wrench light on -- Powertrain or High voltage charge system fault detected. P0D59 BECM-B+EnergyCtrl ($7E4) Proximity Detection Circuit High
  • Vehicle Plug in light on -- Message asked is the vehicle plugged in, after answering NO, message comes back again and again.
  • At this point the green car ready light will not be on, and the car cannot be driven.
  • If you turn off and lock the car and come back 30 minutes later, then unlock the car, the Service engine light will be on and the green car ready to drive light will be on and you can drive off with just the service engine light on.
  • Sometimes the Service engine light will go off by itself and you will go for a few days without any problem.
  • Then the original Service engine, wrench, and Vehicle Plug in light on situation comes back.
  • Sometimes if the passenger door is opened and closed you can get to the point of the Service engine light on and the green ready to drive light on and you can drive off again.
  • If have attached two Diagnostic Reports
Has anyone else encountered this problem and found a fix?
 
1 - 1 of 1 Posts
Top